Determine the Internet Protocol IP address for each new interface. Only full-duplex mode is supported. Boot the OS, if it is not already running. To Configure the Primary Network Interface. Perform the following tasks to prepare an additional network interface:. However, you cannot ping or access network resources from the virtual machine.

Uploader: Dijind
Date Added: 24 February 2012
File Size: 24.8 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 90252
Price: Free* [*Free Regsitration Required]

Do not use a dot in the host name.

Note – The 57144 accompanying the network interface card should identify its type. Each interface on a network must have a unique IP address. Your feedback will help us improve the support experience.

However, you cannot ping or access network resources from the virtual machine. If you are using a PCI network interface card, see the documentation supplied with the card. You need to furnish the address in a later step.

However, in order for other network devices to communicate with the system through the new interface, the IP address and host name for each new interface must be bradcom into the namespace on broadocm network name server.

You must configure any additional interfaces separately, after the OS is installed. VMQ is enabled on a Hyper-V virtual switch only when the system is using gigabit or faster boadcom adapters. Two Sun Gigabit Ethernet bge0 and bge1 interfaces are on one controller and two bge2 and bge3 are on another controller. You can also install a pair of identical PCI network interface cards, or add a single card that provides an interface identical to one of the two on-board Ethernet interfaces.


The network adapter seems to be working in the virtual machine.

Linux Kernel Driver DataBase: CONFIG_TIGON3: Broadcom Tigon3 support

However, in order for other network devices to communicate with the system, you must enter the system’s IP address and host name into the namespace 55714 the network name server. These network adapters are also sold under different model numbers by some server OEMs. Each network device or interface must have a unique IP address. Both full-duplex and half-duplex modes are supported. After completing broacdom procedure, the primary network interface is ready for operation.

If a reboot is not performed, BASP will not install correctly. Consult your network documentation if you need more information about how to connect to your network.

Please contact your server OEM if you need a driver that is specific to your server. Bosna i Hercegovina – Hrvatski. For instructions on configuring the system network interfaces, see:.

Silicom Ltd. | PEG1F Single port Fiber Server Adapter Broadcom® Based

Once the adapter is added, modify the hardware configuration in Advanced Options to change line speed and flow control if desired. The ifconfig 8 mediaopt option can also be used to select either full-duplex or half-duplex modes. For a PCI Ethernet adapter card, see brooadcom documentation supplied with the card.


Skip to main content.

If you have problems establishing a connection between this system and your hub, verify that the Ethernet hub also has the link test function enabled. Connect the other end of the cable to the RJ outlet of the appropriate network device. This media image file can be copied to the target machine directly for installation, or a floppy installation disk can be made. Consult the manual provided with your hub bfoadcom more information about the link integrity test function.

Crna Gora – Srpski.

PEG1F Server Adapter

Boot the OS, if it is not already running. For more information, see Configuring Additional Network Interfaces. If you want to set up an additional network interface, you must configure it separately, after installing the OS.