EUC 150 LAMP DRIVER

Driver does not operate within specification or may switch off. Driver connections to supply control signals and lamp. Learn more – opens in a new window or tab. I am not an expert in the subject of arc lamp power supplies so take my input keeping that in-mind. This component has been evaluated for use in a 55? Again, what’s the polarity of this connector?

Uploader: JoJokinos
Date Added: 4 December 2012
File Size: 23.7 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 46133
Price: Free* [*Free Regsitration Required]

Philips Lampdriver EUC C 00 for a OPTOMA EzPro H LCD Projector | eBay

The lamp driver and all of its parts are connected to primary power, except for the communication bus, which is insulated by means of opto couplers. I also lmap the input polarity. Might serve well as inspiration for searching the hard facts about your ballast, lamp and possible power supply combo. Philips WACS hard d Delivery times may vary, especially during peak periods.

With the older 3-pin connectors this usually means connecting two pins don’t know which one for this ballast. The set-maker has to use an output resistance for their control signals, designed in such a way that the specified min. Learn More – opens in a new window or tab Any international shipping is paid in part to Pitney Bowes Inc. The 3-wire cable might lam; be a lamo circuit to keep the lamp operating at a precise output.

  MTS S100 USB DRIVER DOWNLOAD

In the end-use equipment the lamp duc leads and connector shall be routed, supported, clamped or secured in a manner that is: Example for interfacing set electronics and driver X2. I say this because I don’t see all the components I would expect to see in a constant current arc lamp power supply. UHP ballasts require a “go” signal originally from the mainboard to actually run.

I think they should be compatible, the only problem is that they 510 different connectors so I will have to sloder the wires together and use LOTS of isolation. Lamp current synchronization is optional. In this chapter the different options are mentioned.

Projector Ballast For EIKI LC-NB2UW Lamp Driver Board ECU 150 C/00 lamp power supply

International shipping 10 import charges paid to Pitney Bowes Inc. After power-dip the driver immediately stops, and must be re-ignited by applying the SCI-transition When during ignition the SCI-input becomes Low, the driver will finish the ignition cycle. During the ignition cycle the restrike pulses are superimposed on a typ. This item will be posted through the Global Shipping Program and includes international tracking.

SANYO Lampdriver Board EUC C 00 for EIKI LC NB 2 UW LCD Projector | eBay

This is a private listing and ,amp identity will not be disclosed to anyone except the seller. Introduction The UHP lamp driver has three functions: Back to eBay Home Return to top. I wouldn’t be lanp if you could get any V UHP running with such a ballast. Results of my research so far: Add to watch list Remove from watch list. I would definitely not connect any amount of AC power to the white input connector, I think you’ll destroy the board and lamp.

  LAN 2100 3B MINI PCI ADAPTER DRIVER

Please enter 6 numbers for the Postal Code. The lamp-driver is designed to meet these standards when mounted in the set Special care should be taken during ignition of the lamp laml order to prevent the set electronics in the total application from malfunction.

For optimal lamp performance, please check the LE sheet for details. Heatsink is connected to primary power. Unless otherwise stated the specified values are valid under nominal operating conditions and measured according fig 4.

This means that precautions for mounting and insulation of the driver must be taken. My UHP project The qualifier: Last edited by 3zuli; at Learn more – opens in a new window or tab.